Garage Door Side Seal - Installation Instructions
Suitable for use with manual and automatic up-and-over single piece garage doors only.
It is not suitable for roller shutter or sectional doors.
This product should only be installed by a responsible adult and due care and attention should be paid.
Check you have all components before commencing installation.
Appropriate safety goggles and PPE should be worn during installation.
Measure the size
With a tape measure, measure from the bottom of the frame up to the pivot point of the door.
If there is a gap at the top half of the door, then also measure from the pivot point to the top of the frame.
Mark the pivot point
With a pencil, mark the pivot point on the door frame on both the left and right-hand side of the door
Cut the side seal to length
Cut the side seal to ensure you have 4 lengths which can cover the lower halves and upper halves of the door.
Secure seal to lower halves of frame
Put the washer over the screw and put screw through the plastic seal.
Fix the screw into the back of the lower frame, ensuring that the side seal covers the gap and overlaps with the door.
Continue this process until the side seal is secured tightly on the lower half of the frame on both sides.
Secure seal to upper halves of door
If there is a gap at the top half of the door (above the pivot point, the side seal should be attached to the back of the door itself.
Make sure the seal covers the gap and is overlapping with the frame, and fix in place using the provided screws/washers.
Note: You may need to cut the seal around the door mechanism to fit.
